In the last post, dad had built the chain locker and mum an dad started working on getting all the chain into the bow and the lockers. They used the crane to lift the chain and then lower it into the bow.
Dad put rope on the final chain so it could be lifted up later and taken through the winch. Here's the chain in the locker:
As I mentioned in the last post, dad built the chain lockers out of some old steel and scaffoldin we ad knockin about. Dat is recyclin at its best! heehee. We gots to paint the chain locker once all da works is complete and it will be spray-foamed too when the time comes. We will do that in the future when we don't need to worry about moorin and can remove the anchors for a while. Here's a better view of the locker:
As you can see there are two lockers wiv chain in. Hmmmm - I wonder if you can guess why? Hahaaaa that's right! Coz there are two anchors, so two chains, two lockers!
Here's a pic of Atlantis's bow before work starts on the cutting work for the anchors on a misty cold morning:
Dad started cutting the holes on each side of the hull to house the chain.
Close up as dad cuts the port (landlubbers: left) side of the hull.
Testing that the chain fits frew the hole well:
Testing the chain wiv the first anchor. Don't even ask how we got that there! Ok - you can ask! Well we magically shrunk it and pushed it frew da hole! No? Ok, we used the crane to lower the anchor. Using the crane to hold the anchor in place, we then used a shackle to attach the anchor to the chain and released. Hey presto! One anchor thank you very much!
Here's the chain inside the chain locker, As you can see it fits through the hole well. The hole had to be just right - too big and there's a risk of too much water coming into the bow, risking a flood. Too small and the chain wouldn't release, so no anchor.
Here's the view from above. The angle had to be jut right. Which, of course, it was! Clever
Ok, so, hole cut, chain through, anchor attached. What next? He then welded in steel tubes (fabricated by im) so that the anchor has it's housing to sit in.
Then .... testing of course! Here's a video showing how well everyfin worked:
Here's the anchor in the raised position:
This photo shows the anchor in it's final resting place once the anchor is fully raised:
This photo shows the chain locker with full chain.
Right pay attenshun! Here dus be geeky bit. The anchors weigh 350kgs each! Each section of chain is connected by shackles. The chain section between the shackles is called the "shot" and usually measures 90ft. So, we has 9 shots on board .. meanin we as 810ft of chain! And we had to hammer all the rust of each link "by hand" and checked every single link! I say we, of course, I mean mum an dad! I can't ... no thumb you see?
Well dat is for now, see you again soon. Hope you enjoyed dis update.